How to Bleed Your Bicycle Brakes

Bicycle brakes are an essential component of any bike, and it is important to know how to properly bleed them. When brakes are bled, old fluid is removed and new, clean fluid is put in its place. This ensures that your brakes will work properly and will not become damaged. There are two types of brakes that can be bled, hydraulic and mechanical. Hydraulic brakes are the most common, and they use a sealed system of fluid that does not require bleeding. Mechanical brakes, on the other hand, use cables to actuate the brake pads and will need to be bled periodically. The process of bleeding mechanical brakes is relatively simple and only requires a few tools.If you're like most cyclists, you probably don't think much about your brakes until they stop working properly. But keeping your brakes in good condition is important for both safety and performance. Fortunately, it's easy to bleed your bicycle brakes yourself with just a few tools and some patience. Here's a step-by-step guide to bleeding your bicycle brakes: 1. First, you'll need to gather your supplies. You'll need a brake bleeding kit (available at most bike shops), some rags or old towels, and some DOT 3 or 4 brake fluid. 2. Next, you'll need to remove the wheels from your bike. On most bikes, this is simply a matter of loosening the quick release levers. 3. Once the wheels are off, you'll be able to see the brake pads and the brake calipers. Locate the brake bleeder screws on the calipers. 4. Now, you'll need to attach the brake bleeder kit to the brake bleeder screws. Make sure that the kit is properly sealed so that no air can enter the system. 5. Open the bleeder screws and allow the brake fluid to flow into the catch bottle. Be sure to keep an eye on the level of fluid in the bottle so that it doesn't run out. 6. Once the fluid has stopped flowing, close the bleeder screws and remove the brake bleeder kit. 7. Repeat steps 4-6 until brake fluid is no longer coming out of the bleeder screws when they are opened. 8. Once you're finished bleeding the brakes, be sure to clean up any spilled brake fluid and properly dispose of it. That's all there is to it! Bleeding your bicycle brakes is a simple process that just about anyone can do. Just be sure to take your time and be careful not to spill any brake fluid on your bike or yourself.If your bicycle has hydraulic brakes, bleeding them is a simple process that anyone can do with the right tools. You will need a bleed kit specific to your brake model, DOT fluid, and a few rags. The first step is to remove the brake pads and clean out any debris that may be clogging the system. Next, you will need to open the bleeder screws and attach the bleed kit. Slowly pump the brake lever until you see DOT fluid coming out of the bleed kit. Once the fluid is free of air bubbles, you can close the bleeder screws and reattach the brake pads. You may need to bleed your brakes more often if you ride in wet or muddy conditions.
Back to blog